User's Manual
Table Of Contents
- Safety Information
- Introduction
- Trimble R7 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- Trimble R8 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Appendixes Trimble R7 / Trimble R8
- NMEA-0183 Output
- RTCM Output
- Troubleshooting
- Index
13 Setting up the Receiver
114 Trimble R7/R8 GPS Receiver User Guide
Trimble R8 GPS Receiver Operation
• TRIMMARK IIe
• TRIMTALK™ 450S
• SiteNet™ 450
• SiteNet 900
• Trimble R8 internal 450 transmitter
Internal GSM setup
You can configure the receiver optional internal GSM Module using the
Trimble Survey Controller™ software. For more information, refer to the
Trimble Survey Controller User Guide
.
Internal radio setup
To configure the receiver optional internal radio, use one of the
following:
• The GPS Configurator software
• The WinFlash software
• The Trimble Survey Controller software
For more information, refer to the GPS Configurator Help, the
WinFlash Help, or the Trimble Survey Controller User Guide.
By default, the internal radio has only a few “test” frequencies installed
at the factory. If you purchased the transmit option, the broadcast
frequencies must be programmed at the factory. You can program the
receive frequncies using the WinFlash software. For more information,
see The WinFlash Software, page 135.