User's Manual
Table Of Contents
- Safety Information
- Introduction
- Trimble R7 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- Trimble R8 GPS Receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Appendixes Trimble R7 / Trimble R8
- NMEA-0183 Output
- RTCM Output
- Troubleshooting
- Index
10 Cables and Connectors
88 Trimble R7/R8 GPS Receiver User Guide
Trimble R7 GPS Receiver Operation
This chapter provides pinout information for the Trimble R7 receiver
standard and optional cables. This information can be used to build
special cables for connecting the receiver to devices and instruments
not supported by the standard and optional cables.
10.1Port 1, 2, and 3 Connectors
Figure 10.1 shows the location of the receiver serial ports.
Figure 10.1 Trimble R7 receiver serial ports
Figure 10.2 gives pinout requirements for the connector labeled
Port 1. The pin locations for the Port 2 and Port 3 connectors are
identical.
Port 1 Port 2 Port 3