User's Manual
Table Of Contents
- NOTICE
- CAUTIONS AND WARNINGS
- INTRODUCTION
- FEATURES AND BENEFITS
- SETTING UP THE PDL HIGH POWER BASE
- SETTING UP THE PDL LOW POWER BASE/REPEATER (PDL
- SETTING UP THE PDL ROVER
- TIPS AND TECHNIQUES FOR BEST PERFORMANCE
- FCC RULES AND REGULATIONS
- SERVICE AND SUPPORT
- WARRANTY
- APPENDIX A - SAFETY INFORMATION
- APPENDIX B - PIN-OUTS AND CONNECTORS
- APPENDIX C - TECHNICAL SPECIFICATIONS
SETTING UP THE PDL ROVER
Overview of PDL Rover Radio Modem
Front Panel
Buttons
The ON/OFF button is used to turn the PDL Rover modem on
and off. When not in use, the PDL Rover should be turned off to
conserve battery power.
Turn the unit on by pressing the ON/OFF button and holding it
until the channel display indicator is lit. Turn off the PDL Rover
by pressing the ON/OFF button until the display goes blank.
There is a one-second turn-off delay in the power button to
prevent inadvertent turn off.
The CHANNEL button is used to display and change the
channel. Press the CHANNEL button momentarily to display the
selected channel. To change the channel press the CHANNEL
button once to light the display, and then again to change the
channel. Release the CHANNEL button when the desired
channel is indicated.
Use the CHANNEL button to select the “r” setting. With “r”
selected, the PDL Rover will be placed in AutoRover mode. This
mode automatically selects the channel being used by the PDL
Base. If you are operating in an area with more than one PDL
Base station active, you should manually select the channel of
operation to assure proper operation.