User's Manual

If you opt for password protection the password must be entered

every time you turn the unit on or use the Power key to resume

operation.

WARNING: BE CERTAIN TO REMEMBER THE

PASSWORD. The only way to recover from a forgotten password

is to perform a Clean Boot and you will LOSE all application

software, licenses, settings and data on your unit. See page 12

about how to perform a Clean Boot.

9. Using the expansion ports

To access the expansion ports, use the

Philips screwdriver end of the stylus or a

small #1 Philips head screwdriver to

rotate the two quarter-turn fasteners and

remove the Expansion Cap.

Under the Expansion Cap is a Secure Digital (SD) expansion slot.

(Windows Mobile

6 will not recognize storage cards greater than

2GB). There is also a CompactFlash (CF) type II slot and an 8-pin

custom connector (for third-party developers).

Gently insert cards with the front of the

card facing toward the display side of the

unit. Insert the card into the slot and

release; the card should catch in the slot.

Always push the card in straight, never

at an angle or forced.

To eject an SD card, gently press the top of the card to release it.

To eject a CF card, press the eject button located next to the CF.

NOTE: DO NOT use the unit without reattaching the cap and the

boot. The unit is NOT sealed when the cap or boot is off and water

damage can occur, voiding the warranty.

slot

CF slot

type II