User's Manual

Unit Setup

1. Install the battery

The Lithium-Ion (Li-Ion) battery and battery

cover are shipped detached from the unit.

Insert the battery into the compartment so

the connectors on the battery mate with the

pins in the battery compartment, pressing

firmly. Place the battery door over the

battery, with the flat side of the battery door

at the top.

Remove the cap from the Philips

screwdriver end of the stylus or use a small

#1 Philips head screwdriver to finger tighten

the four screws in the battery door.

NOTE: DO NOT use the screwdriver part

of the stylus on the touchscreen or it will scratch your screen.

Only use the smooth end of the stylus.

2. Charge the battery

The AC adapter that ships with your unit has interchangeable AC

plugs to fit almost every electrical outlet. Connect the appropriate

AC plug to the AC adapter. Plug into an electrical outlet and plug

the barrel end of the AC adapter into the unit. The battery gauge

may not be accurate until it has been fully charged at least one

time and may take up to about 4 ½ hours, depending on the initial

state of the battery. A full charge is indicated by the battery LED

(right side of the unit) turning green.

Warning! Be sure to only use the AC adapter included with your

unit. Use of other adapters will void the product warranty.

IMPORTANT: Fully charge the battery once installed in the unit.

The battery gauge may not be accurate until it has been

fully charged at least one time. The battery LED (right side

of unit) will turn green once fully charged.