User's Manual
Pacifi c Crest
ADL Vantage/ADL Vantage Pro Users Guide
20
Appendix B - Pin-outs and Connectors
The ADL Vantage/ADL Vantage Pro uses a #1-shell, 5-pin circular data/power connector. For a ma ng connector,
Pacifi c Crest recommends using a LEMO P/N FGG.1B.305.CLAD.72Z, or equivalent. Refer to Table 3 and Figure 8
for pin assignments and orienta on. Figure 8 shows a rear view of the pin-outs (looking from behind the connec-
tor).
Table3 - ADL Vantage/Vantage Pro Pin Assignments
Figure 8 – ADL Vantage/Vantage Pro Data/Power Connector
Antenna
The ADL Vantage/ADL Vantage Pro antenna connector is a TNC female. For a ma ng plug, we recommend
Amphenol-brand connectors. Use only high quality 50 Ω impedance cable for the antenna connec on.
Most ADL Vantage/ADL Vantage Pro antennas use industry-standard NMO connectors. The impedance of all ADL
Vantage/ADL Vantage Pro antennas is 50 Ω.
• Connector Manufacturer Contacts
• Contact LEMO at h p://www.lemo.com
• Contact Amphenol at h p://www.amphenol.com
Pin No. Descrip on
1 Power: 9-30 VDC Input
2 Ground for Power
3 RX (DTE)
4 Signal Ground
5 TX (DTE)