User's Manual

Pacific Crest Corporation ADL Access User Guide – Dealer Version Page 21 of 28
TRIMTALK 450S is a proprietary protocol used by Trimble
TRIMTALK™ 450S radios. ADL radios are fully compatible with
TRIMTALK 450S radios, but only when set to TRIMTALK 450S protocol.
Note: If 4FSK modulation is selected on the Modulation Type field of the
Radio Link screen (see above), protocol types that do not support 4FSK
(e.g., TRIMMARK AND TRIMTALK protocol) do not appear in the
Protocol Type field. To select one of these non-4FSK protocols, you must
first select GMSK on the Radio Link screen.
c. Advanced Serial Interface Configuration
Click the Serial Interface screen’s Advanced button to access the following
functions:
i. Soft Break Disabled
ADL Access normally connects to a radio using a technique called Soft
Break whereby you attach a radio, turn it on and click the Connect button.
Checking Soft Break Disabled allows you to reconnect to the radio without
using the Soft Break technique. This is normally done to troubleshoot
connection problems under the guidance of a service technician.
ii. Break to Command
The Break to Command function configures the radio to accept a hard
break signal that puts the radio into command mode. When the Break to
Command is unchecked, any hard break will be ignored.
iii. Turn off radio LCD backlight after 20 seconds
If your ADL radio has an LCD display, it will preserve power by turning off
the display in 20 seconds unless you press any button on the radio’s front
panel. To keep the LCD display turned on, uncheck this function and click
the Advanced screen’s OK button.
M. Dealer Screen
Click the Dealer tab to display the Dealer functionalities: