User's Manual

3
Teaching Additional Fob Transmitters
1. Plug the LED into C6 and the push button into C7 on the
receiver.
2. Turn ignition off and unlock doors.
3. Press and release the programming button 3 times. The LED will
turn on.
4. Press and release any button of each new FOB transmitter once.
The LED will flash and the horn and siren will sound once. Up to
4 transmitters may be programmed at one time.
Notes:
• If you place the system in learn mode and teach nothing, the
system will exit in 10 seconds.
• When new transmitters are taught, all old transmitters are
erased.
• The memory for codes will not be erased if power is removed.
• As soon as the LED turns off, the system is fully functional.
4
Smart Led:
The smart LED indicates system status:
• Slow Flash = Armed
• Off = Disarmed
• Fast Flash = Alarm activated
Dip Switch Setting Assignment
The DIP Switch settings control additional functions. Power to the
receiver should be disconnected and reconnected after a DIP switch is
changed. Functional assignments are described below:
Switch DIP SWITCH SETTINGS
#1 Horn Button
ON = Single Horn
Pulse
OFF = Panic
Mode
#2
Left & Right
Buttons Output
ON = Sustained OFF = Pulse
#3
Double Button
Output
ON = Sustained OFF = Pulse
#4 Button Output ON = Sustained OFF = Pulse
#5
Headlights
Supervision
ON = 0.25 sec.
Pulse
OFF = 30 sec.
#6 Arm Alarm
ON = 1 lock
button press
OFF = 2 lock
button presses
#7
Automatic
Lock/Unlock
ON = Enabled OFF = Disabled
#8
Keypad #5 Output
and fob long unlock
ON = Lights
output for 5 min.
OFF = Aux2
output for 5 min.
#9
Keypad #5 Output
and fob long unlock
ON = Output
0.25 sec. pulse
OFF = Output on
for 5 min.
#10 3
rd
Unlock Output
ON = staggered
with lock
OFF = activated
with unlock