User's Manual

FCC ID: TV2EFOBII

FCC Compliance and Advisory

Statement

This device complies with Part 15 of the FCC rules. Operation is

subject to the following two conditions:(1) this device may not cause

harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for a

Class B digital device, according to Part 15 of the FCC rules. These limits

are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and if not installed and used in

accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try correct the

interference by one or more of the following measures:

1.Reorient the receiving antenna.

2.Increase the separation between the equipment and receiver.

3.Connect the equipment into and outlet on a circuit different from that to

which the receiver is connected.

4.Consult the dealer or an experienced radio/TV technician for help.

Any special accessories needed for compliance must be specified in the

instruction manual.

Warning: A shielded-type power cord is required in order to meet FCC emission limits and also to

prevent interference to the nearby radio and television reception. It is essential that only the

supplied power cord be used. Use only shielded cables to connect I/O devices to this equipment.

CAUSION: Any changes or modifications not expressly approved by the

party responsible for compliance could void your authority to operate the

equipment.