User's Manual

Spectrum Research
& Testing Lab., Inc.
No. 101-10, Ling 8,
Shan-Tong Li, Chung-Li
City, Taoyuan, Taiwan,
R.O.C.
TEST REPORT
Reference No.: A06033011
Report No.: FCCA06033011
Page:
8 of 20
Date: May 12, 2006
FCC ID: TV2EFOBI
5.3 TEST SET-UP
NOTE :
1. The EUT system was put on a wooden table with 0.8m heights above a ground plane.
2. For the actual test configuration, please refer to the photos of testing.
5.4 TEST PROCEDURE
The EUT was tested according to the requirement of ANSI C63.4 and CISPR 22. The
measurements were made at an open area test site with 3 meter measurement
distance under 1 GHz and with 3m distance above 1GHz. The frequency spectrum
measured started from 30 MHz. Under 1 GHz, all readings were quasi-peak values
with 120 kHz resolution bandwidth of the test receiver. Above 1 GHz, the
measurements were made at an open area test site with 3 meter measurement
distance and all readings were peak or average values with 1 MHz resolution
bandwidth of the test receiver. The EUT system was operated in all typical methods
by users. The cables connected to EUT and support units were moved to find the
maximum emission levels for each frequency.
5.5 EUT OPERATING CONDITION
Same as section 2.3 of this report.
5.6 Maximum Modulation Percentage
Duty Cycle = 50%
EMI Receiver
Filter
To Utility
Power
EUT
Ground Plane
3/10m
0.8 m
Coaxial
Cable
Turn Table
1m – 4m
Power Cable