Installation Guide

Notice: The contents of this document are proprietary and confidential and the property of Trilliant Holdings Inc., its subsidiaries, affiliates, and/or
licensors. This document is provided subject to the confidentiality obligations set forth in the agreement between your company and Trilliant. The contents
may not be used or disclosed without the express written consent of Trilliant.
9
Installation Guide for SecureMesh WAN
®
Gateway 2 - PL-0073A
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
l Consult the dealer or an experienced radio/TV technician for help.
Wireless notice
To satisfy FCC and Industry Canada RF Exposure requirements for mobile and base
station transmission devices, a separation distance of 1 m (39.4 in) or more should be
maintained between the antenna of this device and persons during operation. To
ensure compliance, operation at closer than this distance is not recommended.
Pour satisfaire les requis d'Industrie Canada sur les expositions aux radiofréquences
pour les appareils mobiles et les stations de transmission, une distance de 1 m ou plus
doit être maintenue entre l'antenne de cet appareil et les personnes durant l'opération.
Pour assurer la conformité, les opérations à des distances inférieures ne sont pas
recommandées.
WEEE: Waste Electrical and Electronic Equipment Directive
Figure 1: The symbol for used electrical and electronic products