Installation Guide

Notice: The contents of this document are proprietary and confidential and the property of Trilliant Holdings Inc., its subsidiaries, affiliates, and/or
licensors. This document is provided subject to the confidentiality obligations set forth in the agreement between your company and Trilliant. The contents
may not be used or disclosed without the express written consent of Trilliant.
47
Installation Guide for SecureMesh WAN
®
Gateway 2 - PL-0073A
Table 7: RSSI function for normal operating mode
Function Color(s) LED State Condition/Status
RSSI Amber or green Both amber and green off No links
Flashing amber at 1 Hz LRRSSI is 9 or lower.
On amber LRSSI is 10 - 19.
Flashing green at 1 Hz LRSSI is 20 - 29.
On green LRSSI is 30 or larger.
Accessing the CLI using WiFi
The CLI interface is also provided by an internal WiFi module. The module enables a
WiFi connection using a Service Set Identifier/Pre-Shared Key (SSID/PSK). After
establishing a connection via WiFi, a Telnet connection can be opened by using a pre-
configured IP address as described in the following tables (Table 8, Table 9, Table 10,
and Table 11).
Use the following list of commands to configure the Serial to WiFi parameters manually,
to change the active configuration, and or the persistent configuration.
Note: Changing the active configuration will cause the Serial to WiFi
module to reset.