Installation Guide

Notice: The contents of this document are proprietary and confidential and the property of Trilliant Holdings Inc., its subsidiaries, affiliates, and/or
licensors. This document is provided subject to the confidentiality obligations set forth in the agreement between your company and Trilliant. The contents
may not be used or disclosed without the express written consent of Trilliant.
28
Installation Guide for SecureMesh WAN
®
Gateway 2 - PL-0073A
Figure 14: Rubber gasket
5. Connect a 10 AWG ground wire to the surge suppressor’s middle ground nut
using a 1/4” size crimp-on terminal lug (see Figure 15).
6. Feed the ground wire through the X that was cut in the black gasket.
7. Slide the black gasket back into place on the surge suppressor. Tighten the nut
using a 3/8” nut driver (see Figure 15).