Installation Guide

Notice: The contents of this document are proprietary and confidential and the property of Trilliant Holdings Inc., its subsidiaries, affiliates, and/or
licensors. This document is provided subject to the confidentiality obligations set forth in the agreement between your company and Trilliant. The contents
may not be used or disclosed without the express written consent of Trilliant.
31
Installation Guide for SecureMesh
®
WAN Extender 2 - PL-0072A
Figure 17: Attach the ground wire
14. To attach the ground wire to the XTEN-2000, follow one of the steps below:
a. If the ground wire was terminated with a crimp lug, attach the ground wire
to the XTEN-2000 at the pole mount clamp using a 1/4-20 screw, 1/4” flat
washer, and 1/4” lock washer from the accessory kit.
b. If the ground wire end was stripped, attach the ground wire to the XTEN-
2000 at the same location and with the same hardware, but use the
solderless grounding lug (see Figure 18).