Installation Guide

Notice: The contents of this document are proprietary and confidential and the property of Trilliant Holdings Inc., its subsidiaries, affiliates, and/or
licensors. This document is provided subject to the confidentiality obligations set forth in the agreement between your company and Trilliant. The contents
may not be used or disclosed without the express written consent of Trilliant.
23
Installation Guide for SecureMesh
®
WAN Extender 2 - PL-0072A
It is recommended that you build the DSC prior to mounting the XTEN-2000 in the field.
Steps to Prepare the DSC
1. Remove the paper backing on the flat rubber seal and position the seal on the
face of the connector body (see Figure 8).
Note: Ensure the notch in the rubber seal is aligned with the
notch in the connector body and that the seal is centered on
the face of the connector.
Figure 8: Seal
2. Slide the coupling nut over the connector body.
3. Align the two small ribs in the coupling nut to the two slots in the connector
body.
4. Push the coupling nut towards the mating side of the connector body. Once the
nut clicks into place, it should turn freely and remain tethered to the connector
body.