Installation Guide

Notice: The contents of this document are proprietary and confidential and the property of Trilliant Holdings Inc., its subsidiaries, affiliates, and/or
licensors. This document is provided subject to the confidentiality obligations set forth in the agreement between your company and Trilliant. The contents
may not be used or disclosed without the express written consent of Trilliant.
22
Installation Guide for SecureMesh
®
WAN Extender 2 - PL-0072A
Optional steps for using a short mounting pipe
Follow these optional steps if you use a short mounting pipe.
1. Insert the short mounting pipe into the clamp mount/bracket assembly.
2. Ensure the pipe sits fully against the bottom of the clamp mount.
3. Hand-tighten the six 1/4-28" bolts so that the stainless steel mounting bracket
is parallel to the pole mount clamp, and the spacing on each side is roughly
the same.
Preparing the Device Side Cable (DSC)
The Device Side Cable (DSC) is the short Cat6 cable between the XTEN-2000 and the
surge suppressor. It is terminated on one end with an Amphenol LTW IP-67 rated
circular connector. The circular connector comes with the XTEN-2000 accessory kit.
The other end of the DSC is terminated with a shielded RJ45 connector and attaches to
the surge suppressor.
The component parts of the Amphenol LTW circular connector are shown below in
Figure 7 . The circular connector is designed to accept a standard size RJ45 connector
and provide a watertight seal when the coupling nut is tightened.
Figure 7: Components