Installation Guide

Notice: The contents of this document are proprietary and confidential and the property of Trilliant Holdings Inc., its subsidiaries, affiliates, and/or
licensors. This document is provided subject to the confidentiality obligations set forth in the agreement between your company and Trilliant. The contents
may not be used or disclosed without the express written consent of Trilliant.
21
Installation Guide for SecureMesh
®
WAN Extender 2 - PL-0072A
Figure 6: Bottom view of the XTEN-2000 base enclosure
1. Turn the XTEN-2000 upside down to attach the pole clamp mount to the base
of the XTEN-2000.
2. Align the rounded point on the clamp mount with the notch on the base of the
XTEN-2000 (see Figure 6).
3.
Attach the clamp mount to the base using three of the 1/4-20 x 0.75" screws,
1/4" lock washer, and 1/4" a flat washer. Do not insert a screw and washers
into the mounting hole next to the ground symbol.
4.
Place the stainless steel clamp mount bracket next to the pole clamp mount,
and align the six slots in the clamp with the six threaded inserts in the bracket.
5.
Insert a 1/4-28" bolt through each of the slots and partially thread it into the
bracket's threaded insert. Use a 1/4" flat and lock wash on each bolt to protect
the clamp's painted surface, and to help secure the bolt. Repeat for the
remaining five bolts.
6.
There are two lengths of 1/4-28" bolts provided in the accessory kit. Use the
proper length bolt to match the site's pole diameter.