User Manual

SkyPilot SkyAccess DualBand Installation 41
Accessing the Command-Line Interface
SkyPilot devices include a command-line interface which you can use
for manual provisioning and troubleshooting.
You can connect to a device and access its command-line interface
through Telnet over an Ethernet connection or via a terminal session
from a console connected to the device’s RJ-45 serial port. After
logging in (by supplying a password), you can enter commands at the
command prompt.
For detailed cabling and access instructions for the command-line
interface, refer to the SkyPilot Command-Line Interface Reference.
Troubleshooting
After making an Ethernet or serial connection to the SkyConnector, you
can manage and troubleshoot the device using a wide range of
commands available through the command-line interface.
For detailed troubleshooting procedures, refer to the “Troubleshooting”
section in SkyPilot Network Administration. There you’ll find
troubleshooting procedures for:
• Power-on problems
• Ethernet connectivity problems
• IP connectivity problems
• SkyGateway transmission problems
• Link failure problems