User Manual

SkyPilot SkyAccess DualBand Installation 30
Attaching Antennas
Unless you’re installing a DualBand or TriBand, you can skip this
section. To attach the DualBand antennas, see the procedure on page
21; to attach the TriBand antennas, see the procedure on page 22.
To attach the DualBand antennas:
• Connect the 2.4 GHz antennas.
IMPORTANT If you are attaching antenna other than those
provided by SkyPIlot, make sure you use the same type of
antenna to comply with FCC requirements and that the
antenna gain is equal to, or less than the gain of the
SkyPilot antenna.
Screw the antennas onto the standard N-connectors on the bottom
of the DualBand.
Figure 3-11. Attaching the DualBand antennas