User Manual

SkyPilot SkyAccess DualBand Installation 24
connections (recommended), see the procedure on page 16; to cable
the device for Ethernet only, see the procedure on page 19.
IMPORTANT For SkyExtender, DualBand, and TriBand
installations, your view will differ slightly, allowing for
antenna access through the cable covers.
To install cabling for both Ethernet and serial connections:
1 Connect the Ethernet cable.
Run the CAT-5 cable under the gasket and plug it into the Ethernet
port in the cavity on the device base (see Figure 3-2).
Figure 3-2. Attaching weather gasket and metal cover
2 Connect the serial cable.
a. Thread the serial cable through the serial cable cover and
weather gasket, and then plug the connector into the serial
port.