User's Guide

DT-0237A page 33 of 34 Rev: 1.1
CONFIDENTIAL
DISTRIBUTED UNDER LICENSE
If appropriate, compliance with exposure guidelines for mobile and unlicensed devices can be accomplished by the use of warning labels
and by providing users with information concerning minimum separation distances from transmitting structures and proper installation of
antennas.
The following statement must be included as a CAUTION statement in manuals and OEM products to alert users of FCC RF exposure
compliance:
If the OSDI modules are used in a portable application (i.e., the antenna is less than 20 cm from persons during operation), the integrator
is responsible for performing Specific Absorption Rate (SAR) testing in accordance with FCC rules 2.1091.
7.1.2 Approved External Antenna Types
To maintain modular approval in the United States, only the antenna types that have been tested shall be used. It is permissible to use
different antenna manufacturer provided the same antenna type and antenna gain (equal to or less than) is used. Also, the antenna(s)
used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Testing of the OSDI module has been performed with the antenna types listed in Section 4.3 above.
7.1.3 Helpful Web Sites
Federal Communications Commission (FCC):
http://www.fcc.gov
.
Canada
The OSDI module targets certification for use in Canada under Industry Canada (IC) Radio Standards Specification (RSS) RSS-247 and
RSS-Gen. Modular approval permits the installation of a module in a host device without the need to recertify the device.
Labeling Requirements for the Host Device (from Section 7.2, RSP-100, Issue 10, November 2014):
The host device shall be properly labeled to identify the module within the host device.
The Industry Canada certification label of a module shall be clearly visible at all times when installed in the host device, otherwise the host
device must be labeled to display the Industry Canada certification number of the module, preceded by the words “Contains transmitter
module”, or the word “Contains”, or similar wording expressing the same meaning, as follows:
User Manual Notice for License-Exempt Radio Apparatus (from Section 8.4 RSS-Gen, Issue 4, November 2014):
User manuals for license-exempt radio apparatus shall contain the following or equivalent notice in a conspicuous location in the user
manual or alternatively on the device or both:
To satisfy FCC RF Exposure requirements for mobile and base station transmission devices, a separation distance of 20 cm or more
(100 cm or more when collocated with radio RV7-5G1100) should be maintained between the antenna of this device and persons
during operation. To ensure compliance, operation at closer than these distances is not recommended.
Contains transmitter module IC: 6028A-OSDI4W1
Or
Contains IC: 6028A-OSDI4W1
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.