User's Guide

DT-0237A page 20 of 34 Rev: 1.1
CONFIDENTIAL
DISTRIBUTED UNDER LICENSE
However, refer to associated Gerber files for more accurate details on dimensions and refer to Trilliant Networks Inc for more details on
the Gerber files. Table 4 shows the parts used in the reference trace design.
Figure 18 FCC and IC approved trace design layout and picture for external antennas of section 4.3
Table 4 Antenna micro-strip trace parts for external antennas
Part Number Designator Description Manufacturer
N/A G8, G10, G15, G16, G18 Not installed N/A
RK73Z1ETTP G7, G9, G17, R52
RESISTOR 0.0 OHMS 1/16W 5% 0402 SMT
KOA Speer Electronics
LQW18AN75NG00D L2
INDUCTOR 75nH, 2%, 270mA 560mΩ, 0603 SMT
Murata Manufacturing
1-1478979-0 J53
SMA JACK CONNECTOR (FEMALE) PCB Mount 4
legs, SS/Gold pl.
TE Connectivity
As preliminary information for Figure 19, the traces width of all sections are 1mm and the length of each section, starting from the LGA
pad to J5 connector are: LGA pad to G3: 14.18mm; G3 to J5: 5.05mm. However, refer to associated Gerber files for more accurate details
on dimensions and refer to Trilliant Networks Inc for more details on the Gerber files. Table 5 shows the parts used in the reference trace
design.
Figure 19 FCC and IC approved trace design layout and picture for external antennas of section 4.3