Installation Instructions

36 | 6 Verifying Connectivity
 From the command line, use the show link command to confirm that an
active link exists.
The device is online if the output displays an act path (active path) link
state.
For example:
 Use the traceroute command to confirm that you can send and receive
data across the wireless network.
The traceroute command performs a SkyPilot protocol trace that shows
the path to the SkyPilot Gateway Pro. Entering the traceroute command
Table 6-3. SkyPilot Connector LED status lights
LED LED state Device state
Lan Link Steady illumination SkyPilot Connector is connected to
another device via its Ethernet port
LAN Act Blinking Device is transmitting or receiving
data via its Ethernet port
WAN Link Blinking (fast blink
when device is in
standby mode)
Device is attempting to establish an
authorized connection on the
wireless network
Steady illumination Device is connected to the wireless
network
WAN Act None Device cannot detect a wireless
network
Blinking Device is within the coverage area of
a wireless network. Blink indicates
signal strength:
 Fast (8x per second): excellent
 Medium (4x per second): good
 Slow (<1x per second): poor
Node Id LType NType State RSSI LTxMod RTxMod LAnt RAnt
----------------- ----- ----- --------- ---- ------ ------ ---- ---
00:0a:db:00:00:43 data ext act path 39 48 36 2 4