Installation Instructions

Table Of Contents

Confirming SkyPilot Gateway Pro Connectivity | 33

Verifying Connectivity

After provisioning and installing your SkyPilot devices, you should perform the

procedures in the following sections to confirm that the devices are properly

connected to the network.

Confirming SkyPilot Gateway Pro Connectivity

There are two ways to confirm SkyPilot Gateway Pro connectivity:

 Check the LED status lights on the SkyPilot Gateway Pro to verify that the

device is fully online.

See Table 6-1for a summary of what the LED status lights mean. For a detailed

description of the status lights, refer to SkyGateway/SkyExtender Installation

and Setup.

Table 6-1. SkyPilot Gateway Pro LED status lights

Device state Link LED Activity LED

Startup in progress Slow staggered blinking of both LEDs

Startup failure Off On

Initializing image (and

acquiring GPS signal)

Blinks 4 times;

repeats cycle

Blinks 4 times;

repeats cycle

Initialization failure Fast, synchronized blinking of both LEDs

Successful initialization, but

authorization failure

On Off

Connected On On