Installation Instructions

30 | 5 Installing the SkyPilot Gateway Pro
The brackets should be attached so that the body of the bracket is below the
mounting holes. This, in turn, will orient the hook-tab, which is at the other
end of the bracket, down.
IMPORTANTThe double-hinged mounting bracket and the single-hinged
bracket , together, allow you to tilt the unit. If you need to tilt it
down, use the double-hinged bracket on top. If you need to tilt it
up, use the double-hinged bracket on the bottom.
IMPORTANTThe holes in the unit are fine-thread. DO NOT use 1/4-20 UNC
(coarse thread) hardware in these holes.
IMPORTANTThe SkyPilot Gateway Pro case is aluminum. Do no over-torque
the mounting bolts.
NOTE Your SkyPilot Gateway Pro can be wall-mounted. You will need lag bolts or
other fasteners suitable for attaching to the wall. Use them to attach one-
half of the pole clamp to the wall, then hang the SkyPilot Gateway Pro as
described below.
Figure 5-4. SkyPilot Gateway Pro with Mounting Brackets Attached
1/4-28 hex-head bolts
Double-hinge bracket
Single-hinge bracket
Tab
GPS antenna
on bracket