Installation Instructions

Configuring the SkyPilot Gateway Pro | 23
For detailed access instructions for the command-line interface, refer to the
SkyPilot Command-Line Interface Reference.
Manually Provisioning Devices
Manual provisioning stores settings in the device’s flash memory, where they
remain available for recall when the device starts up.
NOTE If you’re installing a device in a location that poses difficulties, consider
delaying the final mounting until you can confirm that provisioning was
successful.
Table 4-2 summarizes the steps required to manually provision a device.
Table 4-2. Manually Provisioning a Device (Page 1 of 2)
Step Refer to
1 Decide whether to
provision the device using
the command-line
interface or the Web
interface.
(For DualBand/ access
points, you must use the
Web interface.)
”Choosing a Manual Provisioning
Method” in SkyPilot Network
Administration
2 Prepare the device for
installation by installing
the necessary cabling,
attaching antennas (for
DualBands), and readying
the device for service.
Do not install the device
yet.
The appropriate installation manual:
 SkyGateway/SkyExtender Installation
and Setup
 SkyConnector Indoor Installation
 SkyConnector Outdoor Installation
3 Power on the device.