Installation Instructions

Powering Up | 21
Powering Up
1 Connect a power cord to the power supply, and plug it in.
2 Connect the Ethernet cable from the SkyPilot Gateway Pro to the port labeled
“Output” on the power supply.
3 Connect an Ethernet cable from the port labeled “Input” to your network.
Monitoring the Power-On Sequence
When the SkyPilot Gateway Pro is powered up, it starts a power-on sequence. You
can monitor itby observing the pair of LED lights on the back of the device. The
power-on sequence may take up to 15 minutes, depending on how quickly the
device can acquire a GPS signal.
NOTE The SkyPilot Gateway Pro must have access to a GPS signal to complete its
power-on sequence and start making wireless network connections.
Depending on your SkyPilot network configuration, the device may be
unable to connect to the network until the device has been configured.
Table 4-1 provides detailed descriptions of device states indicated by the LEDs..
Table 4-1. SkyPilot Gateway Pro LED Status Lights
Device state LED 1 (left) LED 2 (right)
Startup in progress Slow staggered blinking of both LEDs
Startup failure Off On
Initializing image, acquiring GPS signal Blinks 4 times;
repeats
Blinks 4 times;
repeats
Initialization failure Fast, synchronized blinking of both LEDs
Successful initialization, but
authorization failure
Green Off
Successful initialization, but no links
found
Green ???
Connected Green Blue