Installation Instructions

20 | Chapter 4 Configuring the SkyPilot Gateway Pro
GPS Antenna
1 Attach the GPS antenna bracket to the top of the unit, on the back, using two
small Phillips screws. This is shown in Figure 4-3.
2 Connect the GPS antenna cable to the SMA connector on the unit bottom.
3 The GPS antenna is magnetic, and will stick to the mounting bracket.
4 Temporarily place the GPS antenna where it can pick up a GPS signal. You can
use a hand-held GPS device, such as an iPhone, to determine if there is
adequate signal strength in your location.
Figure 4-3. GPS bracket