Installation Instructions

Cabling | 19
c Thread the Ethernet cable through the connector body and plug it into
the RJ-45 receptacle on the circuit board.
d Makes sure there is a little slack in the cable inside the unit, to act as a
strain relief.
e Insert the grey gasket back into the connector, and then tighten the cap
until the cable is securely held.
3 Connect the serial cable. This is done in the same manner as the Ethernet
cable. You must first remove the plug and installed the supplied cable clamp.
The plug unthreads; use a large flat-blade screwdriver or a coin.
4 Re-attach the cover.
5 Use cable ties or Velcro wraps to secure all the cabling against strain.
Figure 4-2. Exploded View of Cable Clamp Assembly
Rubber Plug
Nut
Cat 5 Cable