Installation Instructions

18 | Chapter 4 Configuring the SkyPilot Gateway Pro
Cabling
Ethernet cabling provides power and data connectivity for the SkyPilot Gateway
Pro. Serial cabling provides connectivity for troubleshooting and local
configuration.
Figure 4-1. Cable Connections and Mounting Holes
To install cabling for Ethernet, and optionally serial connections:
1 Remove the access plate from the back of the unit.
2 Connect the Ethernet cable.
a Unscrew the black cable clamp and remove the grey rubber gasket.
b Thread your Ethernet cable through the black plastic cap and then the
grey gasket. In most cases, you can fit the RJ-45 plug through the gasket,
or you can thread the cable through first and them crimp on a connector.
Ethernet Jack
Serial Port
Cable Clamp
Serial Port
Access Hole
Upper
Mount
Holes
Lower
Mount
Holes
GPS
Mount
Holes
Ground Lug
GPS SMA
Connector