Installation Instructions

Table Of Contents

Provisioning | 17

Configuring the SkyPilot Gateway Pro

This chapter provides instructions for configuring the SkyPilot Gateway Pro and

then performing the physical installation.

You should test and configure you SkyPilot Gateway Pro on the bench before

deploying it to the field. To do so, you will need to connect cables and the GPS

antenna.

Chapter Highlights

 Cabling

 Powering up

 Configuring the SkyPilot Gateway Pro

 Accessing the command-line interface

Provisioning

To provision your SkyPilot Gateway Pro, you must:

 Choose a provisioning mode: automatic or manual.

 Prepare the network infrastructure. For automatic provisioning, you must

install SkyPilot software on a supported operating system to create your

Network Management System (NMS)