User's Manual
Table Of Contents
SkyGateway/SkyExtender Installation And Configuration Guide
2-14 September 2004
Figure 2-13 Secure Ethernet Cable
Powering Up 1. Connect the Ethernet cable to the CPE Ethernet Port on the Power Injector, as
shown in Figure 2-14.
Figure 2-14 Connect To Power Injector
2. Connect the power supply to a power source and then connect it to the Power
Port of the Power Injector.
3. Connect a second Ethernet cable from the Computer port of the Power Injector
to the router and the router to the T1 line.