User's Manual
Table Of Contents
SkyGateway/SkyExtender Installation And Configuration
September 2004 2-13
Install Ethernet 1. Connect the Ethernet cable and push it into the gasket. Figure 2-11
below shows this installation.
Figure 2-11 Ethernet Cable
2. Install the cover using the provided screws. The Ethernet cable is
positioned to pass through the insert in the cover, as shown in Figure
2-12.
Figure 2-12 Cover Installed
3.
Secure the Ethernet cable to prevent strain (particularly installations
exposed to high wind conditions). Figure 2-13 shows an example of
the cable secured to the mounting pole.