User's Manual
Table Of Contents
SkyGateway/SkyExtender Installation And Configuration
September 2004 2-11
Figure 2-9 Secure Ethernet Cable
Powering Up
To power up the unit, perform the following steps:
1. Plug the Power Supply into a power source.
2. Connect the Ethernet cable to the
CPE
port of the Power Injector and the Power
Injector to the power supply, as shown in Figure 2-10.
Figure 2-10 Connection To Power Injector
3. Connect a second Ethernet cable from the
Computer
port of the Power Injector
to the router and the router to the T1 line.