User's Manual
Table Of Contents
SkyGateway/SkyExtender Installation And Configuration
September 2004 2-7
Install Cabling
NOTE:
Cables must be installed in accordance with NEC Article 725 and 800, and
all requirements must meet in relationship to clearances with power lines
and lighting conductors. All cabling must be category 5e per TIA/EIA-568-
B.2.
Both units support Power over Ethernet (PoE) utilizing the Power Injector provided,
as shown in Figure 2-2.
Figure 2-2 Power Injector
.
Both units provide a 10/100bT connector and the SkyGateWay provides a serial
interface. The 10/100bT Ethernet port provides interconnectivity for user and
network traffic, while the serial port is used for local access to the Command Line
Interface.
To install SkyGateWay, see “SkyGateWay Installation” on page 2-8.
To install SkyExtender. see “SkyExtender Installation” on page 2-12.
WARNING
The units should be installed with the
SkyPilot-provided Power Injector only
.
The use of other PoE Power Injectors could result in damage to the unit. Also
do not plug a computer, switch, etc. into the CPE connector on the PoE injector.
!