User's Manual

SKYPILOT NETWORK CONFIDENTIAL AND PROPRIETARY
Page
SKYPILOT NETWORK CONFIDENTIAL AND PROPRIETARY
12
4.2 SD1000 Configuration
A SD1000 must be configured for the following:
1. IP Address Mode – DHCP or Manual
2. Management IP Address and Mask (if manually configure)
3. Ethernet Port Control
4. QoS Data Rates
4.2.1 IP Address Management
The SD1000 management interface (SNMP, Telnet) requires the allocation of an IP
address. It can be configured to use either DHCP for dynamic IP address allocation or can
be statically configured via the CLI.
DHCP is the default. For static allocation the IP Address, Netmask and IP Default
Gateway must be input via the CLI. See Section 5 for details.
4.2.2 Ethernet Port Control
The SD1000 allows for the disabling (and enabling) of the 10/100bT Ethernet port.
Default is disabled. The disabling of the Ethernet port is recommended in the case of
Seed Only application (i.e. when there is no subscriber interface). The enable/disable
Ethernet port facility can also be used to control subscriber access in the case of a CPE
Only or Combined application.
4.2.3 Subscriber Data Rates
The SD1000 allows for configuration of maximum downstream and upstream data rates.
These values are selected from a list of defined options. The values relate to traffic sent
and received over the Ethernet port and are not applicable in the case of a Seed Only
application.