User's Manual

SecureMesh FocusP Radio Module

INSTALLATION INSTRUCTIONS

The Trilliant SecureMesh FocusP Radio Module is a 2.4GHz 802.15.4 transceiver radio module intended

for use in electric meters, gas meters, and network product and in home products for utility

applications. The module contains its permanently attached antenna board, the “L” shaped antenna

with 1.1 dBi of gain. The module also allows direct connection for an optional U.FL connector. Power is

supplied by a host module with a nominal voltage of 15 Vdc with an enable input of 5 Vdc.

Specification of the radio module:

IEEE standard: 802.15.4

Power Output : +30 dBm

Radio Sensitivity: ‐99 dBm

RF Data Rate: 250 kbps

Operating Frequency: 2.400‐2.483GHz

Network Topology: Mesh

Modulation: O‐QPSK

Antenna Options: U.FL

Trilliant Responsibilities to comply with FCC and Industry Canada Regulations

The SecureMesh FocusP radio module has been certified for integration into products only by a

professional under the following conditions:

1. The antenna(s) must be installed such that a minimum separation distance of 20cm is

maintained between the radiator (antenna) and all persons at all times.

2. The transmitter module must not be co-located or operating in conjunction with any other

antenna or transmitter.

As long as the two conditions above are met, further transmitter testing will not be required.

However, Trilliant is still responsible for testing their end-product for any additional compliance

requirements required with this module installed (for example, digital device emissions, PC

peripheral requirements, etc.).

IMPORTANT NOTE: In the event that these conditions cannot be met (for certain configurations or

co-location with another transmitter), then the FCC and Industry Canada authorizations are no

longer considered valid and the FCC ID and IC Certification Number cannot be used on the

final product. In these circumstances, Trilliant integrator will be responsible for re-evaluating the

end product (including the transmitter) and obtaining a separate FCC and Industry Canada

authorization.

Trilliant will not provide information to the end user regarding how to install or remove this RF

module or change RF related parameters in the user manual of the end product. The module

will be professionally installed inside a meter. The meter will be professionally installed by

employees of a utility – who are professionals in their field.

PAGE 1
SecureMesh FocusP Radio Module INSTALLATION INSTRUCTIONS The Trilliant SecureMesh FocusP Radio Module is a 2.4GHz 802.15.4 transceiver radio module intended for use in electric meters, gas meters, and network product and in home products for utility applications. The module contains its permanently attached antenna board, the “L” shaped antenna with 1.1 dBi of gain. The module also allows direct connection for an optional U.FL connector.
PAGE 2
Product Labeling The Trilliant SecureMesh FocusP Radio Module is labeled with its own FCC ID and IC Certification Number. If the FCC ID and IC Certification Number are not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module.
PAGE 3
Industry Canada Statements This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.