User's Manual


Trilliant, Inc. 1100 Island Drive, Suite 201 Redwood City, CA 94065 [phone] Page 3 of 3
Industry Canada Statements
The following statement must be included as a CAUTION statement to alert users of Industry
Canada RF exposure compliance:
The Trilliant SecureMesh 1 Watt Radio Module must only use the approved antenna(s) listed
above, which have been certified with this module.
Antennas Approved for use
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 6.0 dB. Antennas not included in this list or having a gain greater than 6.0 dB
are strictly prohibited for use with this device. The required antenna impedance is 50 ohms. The
maximum gain antenna is the Mobile Mark OD6-2400 (6dbi gain).
 Mobile Mark OD6-2400 (6dBi gain)
 PCB Trace Inverted-L Antenna (1.1 dBi gain)
 Mobile Mark CVS-2400-2SA-BLK-13
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
To satisfy Industry Canada RF Exposure requirements for mobile and base station transmission devices, a
separation distance of 20 cm or more should be maintained between the antenna of this device and
persons during operation. To ensure compliance, operation at closer than this distance is not
recommended.
Pour satisfaire les requis d'industrie Canda sur les expositions aux radiofréquences pour les appareils
mobiles et les stations de transmission, une distance de 20 cm ou plus doit être maintenue entre l'antenne
de cet appareil et les personnes durant l'opération. Pour assurer la conformité, les opérations à des
distances inférieures ne sont pas recommandées.