User's Manual

SECUREMESH 1 WATT RADIO MODULE
INSTALLATION INSTRUCTIONS 
January12,2016
TheTrilliant1WattSecureMeshRadioModuleisa2.4GHz802.15.4transceiverradiomoduleintended
foruseinelectricmeters,gasmeters,andnetworkproductandinhomeproductsforutility
applications.Themodulecontains castellationsforconnectionstoexternalantennaboard,suchasthe
1.1dBi“L”
shapedantenna.ThemodulealsoallowsdirectconnectionforanoptionalU.FLconnector.
Powerissuppliedbyahostmodulewithanominalvoltageof3.3volts.
Specificationoftheradiomodule:
IEEEstandard:802.15.4
PowerOutput:+30dBm
RadioSensitivity:‐99dBm
RFDataRate:250kb ps
Operating
Frequency:2.400‐2.483GHz
NetworkTopology:Mesh
Modulation:O‐QPSK
PhysicalDimensions:1.400”x2.075”
AntennaOptions:CastellationtoExternalBoard,U.FL
Trilliant Responsibilities to comply with FCC and Industry Canada Regulations
The SecureMesh 1 Watt Radio Module has been certified for integration into products only by a
professional under the following conditions:
1. The antenna(s) must be installed such that a minimum separation distance of 20cm is
maintained between the radiator (antenna) and all persons at all times.
2. The transmitter module must not be co-located or operating in conjunction with any other
antenna or transmitter.
As long as the two conditions above are met, further transmitter testing will not be required.
However, Trilliant is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC
peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for certain configurations or
co-location with another transmitter), then the FCC and Industry Canada authorizations are no
longer considered valid and the FCC ID and IC Certification Number cannot be used on the
final product. In these circumstances, Trilliant integrator will be responsible for re-evaluating the
end product (including the transmitter) and obtaining a separate FCC and Industry Canada
authorization.
Trilliant will not provide information to the end user regarding how to install or remove this RF
module or change RF related parameters in the user manual of the end product. The module
will be professionally installed inside a meter. The meter will be professionally installed by
employees of a utility – who are professionals in their field.