User Manual

ManualsBrandsTrilliant Networks ManualsElectronics802.15.4 Transceiver Module

Trilliant Networks High Sensitivity 1 Watt

odu

sta

n In

uct

Januar

2008

The Trilliant Networks High Sensitivity 1 Watt Radio Module is a 2.4GHz 802.15.4 data

transceiver module. The module contains a trance antenna or optional U.FL connector. Power is

supplied by a host module with a nominal operating voltage of 3.3 volts.

Specification of the radio includes:

IEEE Standard: 802.15.4

Power Output: +30 dBm

Radio Sensitivity: -101 dBm

RF Data Rate: 250kbps

Operating Frequency: 2.4-2.485 GHz

Bit Error Rate: 7*10-7 @-101dBm

Network Topology: Mesh, Point to Point

Spread Spectrum: Direct Sequence

Modulation: O-QPSK

Radio Dimensions: 1.0” x 1.5”

Antenna Options: Directional trace antenna or U.FL external

Power Settings Note:

The maximum power setting possible for the module is 15, however, the manufacturer will set the

maximum at 13 by means of firmware. The end user will not have access to power control and

thus will limit the maximum power setting at 13. Power settings as listed below will be set by the

manufacturer in the final product.

Although the end user does not have access to channel power settings, it is important to note that

FCC approval for this module has been granted subject to channel power settings as stated below.

Any deviation from said power level (P.L) would void the FCC Grant.

Module with DiPole Antenna

Channel P.L

0 7

1 13

2 13

3 13

4 13

5 13

6 13

7 13

8 13

9 13

10 13

11 13

12 11

13 7

14 5

15 0

Summary of content (4 pages)

PAGE 1
Trilliant Networks High Sensitivity 1 Watt Radio Module Installation Instructions January 18, 2008 The Trilliant Networks High Sensitivity 1 Watt Radio Module is a 2.4GHz 802.15.4 data transceiver module. The module contains a trance antenna or optional U.FL connector. Power is supplied by a host module with a nominal operating voltage of 3.3 volts.
PAGE 2
Module with Inv. F Antenna Channel 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 P.L 7 13 13 13 13 13 13 13 13 13 13 13 13 11 7 15 0 Compliance Statement (Part 15.19) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation. FCC Interference Statement (Part 15.
PAGE 3
Module must ensure that the information provided on the 30 dB Radio Module Label is placed on the outside of the final product. The 30 dB Radio Module is labeled with its own FCC ID Number. If the FCC ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module.
PAGE 4