User's Manual

SkyPilot SkyExtender DualBand Installation and Setup Guide 55
Maximum Remote Session.
Use this field to enter the number of simultaneous
remote SSH or Telnet sessions that are allowed. If the value is 0, unlimited
sessions are allowed.
Remote Session Idle Timeout.
Use this field to specify how long (in minutes) an
SSH or Telnet session will stay connected without activity. If the value is 0, the idle
timeout is unlimited.
Peer to Peer.
Check to block Layer 2 broadcast and ARP traffic between wireless
clients. Enable
Peer to Peer
in a public network if you want to prevent users from
“sniffing” traffic or creating accidental “network neighborhoods” at the Ethernet
or VLAN level. A private enterprise network may want to disable
Peer to Peer
to
permit shared LAN services such as file sharing.
Management from Wireless Clients.
Check to allow management of the access
point from wireless clients.
SysLog to Remote Server.
Check to allow login to a remore server.
Radius Server Setting area
Radius servers supply backend authentication services for 802.1x or WPA WLAN
security. The Radius Server Setting area of the Access Point Configuration page
needs to be configured only if 802.1x or WPA authentication will be used in any
of the WLANs. If so, you must provide at least the primary Radius host
information. Secondary host parameters are optional; however, use of a
secondary host is highly recommended for consumer installations.
Figure 38. Radius Server Setting area of Access Point Configuration page