Installation Guide

SecureMesh

Extender Installation Guide

Trilliant Incorporated page 20 of 21

APPENDIX B

Regulatory Information

Federal Communications Commission (FCC) compliance notices

This section includes the following FCC statements for the XTEN-1100-A, SP-2530-A and related SecureMesh™ and SkyPilot by

Trilliant Extenders:

• FCC ID: RV7-5G1100 (Applies to XTEN -1100-A and SP-2530-A)

• Class A Interference Statement

• RF Radiation Exposure and Hazard Warning

• Non-Modification Statement

• Deployment Statement

Class A Interference Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a commercial installation. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired

operation.

RF Radiation Exposure & Hazard Statement

To ensure compliance with FCC RF exposure requirements, this device must be installed in a location such that the antenna of the

device will be greater than 20 cm (8 in.) away from all persons. Using higher gain antennas and types of antennas not covered under

the FCC certification of this product is not allowed. Installers of the radio and end users of the product must adhere to the installation

instructions provided in this manual. This transmitter must not be co-located or operated in conjunction with any other antenna or

transmitter.

Non-Modification Statement

Use only the supplied internal antenna. Unauthorized antennas, modifications, or attachments could damage the XTEN -1100-A and

SP-2530-A and related SecureMesh™ and SkyPilot by Trilliant products and violate FCC regulations. Any changes or modifications not

expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

Deployment Statement

This product is certified for indoor deployment only in the 5150 – 5250 MHz band. Do not install or use this product outdoors in that

frequency band in the United States.

Dynamic Frequency Selection (DFS) in the 5.0 GHz UNII bands

The XTEN -1100-A and SP-2530-A have been prohibited from operating in the 5600 to 5650 MHz frequency band for the US and

Canada in order to comply with the DFS requirements as outlined in the FCC Part 15, Subpart E rules.