User's Manual

www.trilithic.com
www.trilithic.com
Page IV-16
802 AWE Operation Manual
Advanced Wireless Test Set
Finding Devices
The Device Finder screen shows the signal level over
time for a single device in the form of a bar graph.
• The vertical axis (up/down) of the graph
represents the signal level of the selected
device. The graph displays a maximum level of
-30 dBm (top of graph) and minimum level of
-90 dBm (bottom of graph).
• The horizontal axis (left/right) of the graph
represents the number of measurement
samples taken from when you rst entered
the Device Finder screen or selected a new
device.
This screen displays the following information about the selected device:
• MAC – Device MAC Address
• SSID – Access Point Name
• Power – Signal Power Level
• CH – Wireless Channel
The internal speaker of the 802 AWE will emit an audible beeping sound when trying to locate
devices.
• As the user moves closer to the device they are trying to nd, the beeping becomes
more frequent and increases in tone.
• When the user moves away from the device, the beeping becomes less frequent and
decreases in tone.
• Select the Mute softkey to disable the beeping sound or select the Unmute softkey to
enable the beeping sound.
The measurement samples continuously move from the right side of the graph toward the left
side of the graph.
• The newest measurement sample is displayed at the far right side of the screen.
• The oldest measurement sample is displayed at the far left side of the screen.
• The graph can display 70 measurement samples over a time period of approximately 45
seconds, as shown in the image above.