User's Manual

www.trilithic.com
www.trilithic.com
Page IV-28
802 AWE Operation Manual
Advanced Wireless Test Set
Traceroute
When the Traceroute mode is selected, the
following measurement results are displayed as
shown in the image to the right:
• Hop – This is the number of the
intermediary point (hop) in the route
between the meter and the destination
address.
• Address – This is the IP address of the
corresponding intermediary point (hop).
• Name – This is the name of the
corresponding intermediary point (hop).
• Time – This is the time to each intermediary point (hop).
Setting the ACTS Port
To manually enter the ACTS server port for the
throughput test, highlight the ACTS Port eld
as shown in the image to the right and then use
either of the following methods to change the
port:
• Use the up/down arrow buttons to adjust
the port number.
• Press the Enter button and use the
Virtual Keyboard to directly enter the
ACTS port as shown in the image to the
right.
The default ACTS port is set to 28657.