User's Manual

www.trilithic.com

Page III-19

802 AWE Operation Manual

Advanced Wireless Test Set

Finding Devices

Perform the following steps to nd the selected device:

1. Use the up/down arrow buttons on the keypad

to scroll through the Wi-Fi Clients. The currently

selected Wi-Fi client is highlighted in blue as

shown in the image to the right.

2. Select the Find softkey.

3. The Device Finder screen will be displayed as

shown in the image to the right.

• This screen displays the following

information about the selected device:

• MAC – Device MAC Address

• SSID – Access Point Name

• Power – Signal Power Level

• CH – Wireless Channel

• The internal speaker of the 802 AWE

will emit an audible beeping sound when

trying to locate devices.

• As the user moves closer to the

device they are trying to nd, the

beeping becomes more frequent

and increases in tone.

• When the user moves away from the device, the beeping becomes less

frequent and decreases in tone.

• Select the Mute softkey to disable the beeping sound or select the

Unmute softkey to enable the beeping sound.

• The vertical axis (up/down) of the graph represents the signal level of the

selected device. The graph displays a maximum level of -30 dBm (top of graph)

and minimum level of -90 dBm (bottom of graph).

• The horizontal axis (left/right) of the graph represents the number of

measurement samples taken from when you rst entered the Device Finder

screen.