User's Manual

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
Pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
Protection against harmful interference in a residential installation. This equipment generates
Uses and can radiate radio frequency energy and, if not installed and used in accordance
With the instructions, may cause harmful interference to radio communications. However,
There is no guarantee that interference, Will not occur in a particular installation. If this equipment
Does cause harmful interference to radio or television reception, which can be determined by turning
The equipment off and on, the user is encouraged to try to correct the interference by one or
More of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an Outlet on a circuit different from that to which the receiver is connected.
CAUTION: The operation of this radio in the 5.15-5.25 GHz frequency band is restricted to indoor use only.
To OEM Installer:
1. FCC and IC ID on the final system must be labeled with “Contains FCC ID: P4V-
RP1103N” and
IC: 7020A-RP1103N or “Contains transmitter Module FCC ID: P4V-RP1103N“ and
“Contains transmitter Module IC: 7020A-RP1103N"
2. In the user manual, final system integrator must ensure that there is no instruction provided in the user
Manual to install or remove the transmitter module.
3. Transmitter module must be installed used in strict accordance with the
Manufacturer’s instructions as described in the user documentation that comes with the product.
The user manual of the final host system must contain the following statements:
This device complies with Part 15 of the FCC rules. Operation is subject to following
Two conditions: 1. this device may not cause harmful interference and 2. This device
Must accept any interference received including interference that may cause undesired operation of this device.
The changes or modifications not expressly approved by the party responsible for
Compliance could void the user’s authority to operate the equipment.
To comply with the FCC RF exposure compliance requirements, this device and its antenna must not
Be co-located or operating to conjunction with any other antenna or transmitter, except if installed
In compliance with FCC Multi Transmitter procedures.
To inherit the modular approval, the antennas for this transmitter must be installed to provide a
Separation distance of at least 20cm from all persons and must not be co-located or operating in
Conjunction with any other antenna or transmitter.
Note:
The buyer of the module who will incorporate this module into his host must submit the final product to the
Manufacturer of the module and the MANUFACTURER OF THE MODULE WILL VERIFY that the product
Is incorporated in host equipment in a way that is represented by the testing as shown in the test report.
Redpine Signals, Inc. Proprietary and Confidential Page 13
RS91 1 0 -N-1 1 -0 3 Eval u ati on B o ard
User Guide
Us e r Gu i d e
Version 1.5
Ver s i o n 1.5