User's Manual

R
S91 1 0 -N-1 1 -0 3 Eval u ati on B o ard
User Guide
Us e r Gu i d e
Version 1.5
Ver s i o n 1.5
Redpine Signals, Inc. Proprietary and Confidential
Page 12
S. No
Signal Names
C
onnector Pin No.
15)
BT_ACTIVE
J8.16
16)
VRF28 (DO NOT USE)
J8.17
17)
Gnd
J8.18,19&20
3.3: SD Memory Interface
Redpine Signals, Inc. Proprietary and Confidential
Page 12
S. No
Signal Names
C
onnector Pin No.
15)
BT_ACTIVE
J8.16
16)
VRF28 (DO NOT USE)
J8.17
17)
Gnd
J8.18,19&20
3.3: SD Memory Interface
S. No.
Signal Names
C
onnector Pin No.
1)8
CS
J9.1
2)8
DI
J9.2
3)8
Supply
J9.3
4)
SCLK
J9.4
5)8
GND
J9.5
6)8
DO
J9.6
7)8
CD
J9.6
R
S91 1 0 -N-1 1 -0 3 Eval u ati on B o ard
User Guide
Us e r Gu i d e
Version 1.5
Ver s i o n 1.5
4
: Compliance Statements:
4.1 FCC Compliance Statements
This device complies with Part 15 of the FCC rules. Operation is subject to following
Two conditions: 1. this device may not cause harmful interference and 2. This device
Must accept any interference received including interference that may cause undesired
Operation of this device.
The changes or modifications not expressly approved by the party responsible for
Compliance could void the user’s authority to operate the equipment.
To comply with the FCC RF exposure compliance requirements, this device and its antenna
Must not be co-located or operating to conjunction with any other antenna or transmitter,
Except if installed in compliance with FCC Multi Transmitter procedures.
To inherit the modular approval, the antennas for this transmitter must be installed to provide
A separation distance of 20cm from all persons and must not be co-located or operating in
Conjunction with any other antenna or transmitter.