User's Manual

54
Seeker & Seeker MCA III Operation Manual
MCA III Error Codes
The codes shown below are displayed on the Seeker
MCA III display screen or on the MCA III display screen as
“DEVICE ERRORS” to indicate an error with the MCA II.
“E##”
Code
ErrorDescription Solution
0 No errors detected N/A
3
Factory Calibration is
not valid
Return the device to the factory for repair.
4
User Parameters are
not valid
UseSeekerSetuptorecongurethedevice.
7
Invalid Flash ID
detected
Cycle power on the unit, if the error persists return
the device to the factory for repair.
8 Flash memory is Full
Use any of the means available to either erase the
data, synchronize to the meter, or move the data to a
valid LAW connection.
9
Flash memory write
failed
If the error persists, return the device to the factory
for repair.
10 Wi-Fi Post failed
If the error persists, return the device to the factory
for repair.
11
Wi-Fi module
communications failed
If the error persists, return the device to the factory
for repair.