User's Manual
Table Of Contents
- Chapter 1
- General Information
- Helpful Website
- Where to Get Technical Support
- How this Manual is Organized
- Optional Software
- Conventions Used in this Manual
- Precautions
- Chapter 2
- Seeker Introduction
- What is the Seeker?
- Seeker Features
- Easy Frequency Configuration
- Multiple Frequency Presets
- Channel Tag Compatibility
- GT Noise Discrimination
- Squelch Operation
- Source Localization
- Vehicle Battery Protection
- Equipment Supplied with Your Seeker
- Accessories & Replacement Parts for Your Seeker
- A Guided Tour of Your Seeker
- Front View
- Back View
- Right Side View
- Bottom View
- Display Screen
- A Guided Tour of Your Mobile Mount
- Front View
- Left Side View
- Rear View
- About Your Seeker’s Battery
- Overview
- If Your Seeker Does Not Turn On
- Checking the Battery Level
- Charging the Battery
- Updating Your Seeker’s Firmware
- Chapter 3
- Seeker Operation
- Configure Settings
- Seeker’s Operation Modes
- Measurement Mode
- PC Communications Mode
- Display Modes
- Signal Level
- Battery Charge Level
- Peak Hold
- Preset Frequencies
- Channel Tag
- Snapshot Modes
- Pre-Fix
- Post-Fix
- No Snapshot
- Chapter 4
- Leakage Testing
- Before You Begin Leakage Testing
- Testing For Leaks
- Chapter 5
- Seeker MCA III Introduction
- What is Seeker GPS?
- Equipment Supplied with Your Seeker MCA III
- Accessories for Your Seeker MCA III
- Device Overview
- Front View
- Left Side View
- Rear View
- Display Screen Overview
- Chapter 6
- Seeker MCA III Operation
- Configure Settings
- Seeker GPS Display Modes
- Mobile Mount Communication Successful
- GPS Signal
- Data Synchronization
- Chapter 7
- Data Upload Options
- Standard Internet Connection
- Wi-Fi
- Fleet Management System Integration
- Chapter 8
- Appendix
- General Specifications
- Display Messages & Error Codes
- Seeker Error Codes
- MCA III Error Codes
- Access Point Error Codes
- Seeker & MCA II Communication Messages
- Seeker & MCA II Memory Full Messages
- Trilithic Broadband Instruments 2-Year Limited Warranty
53
Seeker & Seeker MCA III Operation Manual
“E##”
Code
ErrorDescription Solution
07 Sync Error
A problem occurred during a hot sync from an
MCA back into a meter. This is most likely a
communication error with the MCA. Try the sync
process again.
08 Bad Flash ID
The flash ID read did not correspond to either the
ST M25P64 or Winbond W25X64 device. If a power
cycle does not fix this, then return to the factory for
repair.
09 RTC Error
The RTC power-on test failed (the value read from
a RAM location in the RTC did not match the value
written). If a power cycle does not fix this, then return
to the factory for repair.
10 Pairing Error
An error occurred during the meter/MCA pairing
process. Retrigger the meter for pairing and try
again.
11 Pairing Error
The meter is not paired with the connected MCA. If
they are the correct meter and MCA, then retrigger
the meter for pairing and try again.