User's Manual

52
Seeker & Seeker MCA III Operation Manual
Display Messages & Error Codes
Seeker Error Codes
The codes shown below are displayed on the Seeker display
screen as “E##” to indicate an error with the Seeker.
“E##”
Code
ErrorDescription Solution
01 Factory 1 Parameters
The checksum is not valid for this area or the
calibration date for this area is not set. Factory 1
contains the filter, level, and GT calibration items. If
a power cycle does not fix this, return to the factory
for recalibration.
02 Factory 2 Parameters
The checksum is not valid for this area or the
calibration date for this area is not set. Factory 2
contains the temperature calibration items. If a
power cycle does not fix this, return to the factory for
recalibration.
03 Bad Identity
The identity voltage read does not correspond to a
known configuration. If a power cycle does not fix
this, return to the factory for repair.
04
Temperature Calibration
Trigger
There was an error re-writing the temperature
calibration trigger pattern when starting the
temperature cal cycle. The meter probably needs to
be retriggered by CalibrATE.
05
Temperature Calibration
Write
An error occurred while writing values during the
temperature calibration cycle. Power cycling the
meter will probably return back to the “”THnn””
display and start the temp cal cycle over again.
06
Factory 2 Parameters
Pending
This happens when the meter is power-cycled after
the temperature calibration cycle has completed, but
CalibrATE has not yet read and checked the results.